To install or replace the filter in your faucet system, remove the device from your faucet by unscrewing the threaded mounting nut.
1. Twist back cover off
2. Insert filter into the device (Don’t worry, the filter will fit loosely)
3. Replace back cover
Before first use, run cold water for 5 minutes in a filtered position. During filter flush, it is normal to see cloudy water and hear the sound of water pushing air out of the filter cartridge. Flushing removes any loose materials, which is normal. Prior to each use, run cold water for 5 seconds in a filtered position to activate the filter.
Change your filter every three months for best performance.
To setup install or replace a filter in your pitcher or dispenser, follow these simple steps or watch our video.
If you have a PUR Plus filter, soak the filter in cold water for 15 minutes. Then hold the filter under cold running tap water for 10 seconds. Allow excess to drain.
If you have a PUR basic filter, rinse filter under cold water for 15 seconds.
Insert the filter into the tray. Push down and twist clockwise to lock. If you have done this prior to putting the tray in the pitcher, you can firmly hit the bottom of the filter to assure it is in place.
Change your filter every 2 months for best performance.
